Simulation and Test Analysis on Effect of Current Density on Electrodepositing Minuteness Structure under Supercritical Fluids

Authors

  • Haifeng QIAN Jiangsu University of Technology
  • Weining LEI Jiangsu University of Technology
  • Weiqiao LIU Jiangsu University of Technology
  • Caoyang GU Jiangsu Union Technical Institute

DOI:

https://doi.org/10.5755/j01.ms.24.2.17612

Keywords:

supercritical fluid, electrodepositing, minuteness groove, simulation, surface morphology

Abstract

This study simulates the electric field of the supercritical electrodepositing system using Comsol software. The effects of the current density on the Ni2+ concentration distribution and the electrodepositing film growth on the cathodic surface are analyzed. The surface morphology and micro-hardness were discussed first. The results show that the electric field is uniformly distributed inside the minuteness groove. The average Ni2+ concentration on the cathodic surface decreases at first, but then increases with the proceeding electrodepositing process; the growth of the electrodepositing films is similar to the distribution of the cathodic current density. The grain size and organization of the Ni-diamond composite electrodepositing minuteness films under supercritical fluid are fine and compact. Moreover, the micro-hardness of the sample reaches 900.75 HV (200 g), a figure that is 70 % higher than that of traditional electrodepositing when the current density is 700 A/m2, the electrodepositing temperature is 323 K, the supercritical pressure is 12 MPa, and the nano-diamond particles content is 30 g/L.

DOI: http://dx.doi.org/10.5755/j01.ms.24.2.17612

Downloads

Published

2018-05-22

Issue

Section

ELECTRONIC AND OPTICAL MATERIALS