Investigation of Hot Rolling Influence on the Explosive-Welded Clad Plate

Authors

  • Guanghui ZHAO Taiyuan University of Science and Technology
  • Qingxue HUANG Taiyuan University of Science and Technology
  • Cunlong ZHOU Taiyuan University of Science and Technology
  • Xiaorong YANG Taiyuan University of Science and Technology
  • Guangming LIU Taiyuan University of Science and Technology
  • Lifeng MA Taiyuan University of Science and Technology

DOI:

https://doi.org/10.5755/j01.ms.22.4.12409

Keywords:

rolling reduction, clad plate, mechanical properties, microstructure, fractography

Abstract

The microstructure, the shear strength and tensile strength of stainless steel explosive-welded clad plate at different rolling reduction were studied. The mechanical properties of the explosive-welded and explosive-rolled clad plates were experimentally measured. Simultaneously, the microstructures of the clad plate were investigated by the Ultra deep microscope and the tensile fracture surface were observed by the scan electron microscope (SEM). It was observed that the tensile strength has been increased considerably, whereas the elongation percentage has been reduced with the increase of hot rolling reduction. In the tensile shear test, the bond strength is higher than the strength of the ferritic stainless steel layer and meets the relevant known standard criterion. Microstructural evaluations showed that the grain of the stainless steel and steel refined with the increase of thickness reduction. Examination of the tensile fracture surfaces reveal that, after hot rolling, the fracture in the low alloy steel and ferritic stainless steel clad plates is of the ductile type.

DOI: http://dx.doi.org/10.5755/j01.ms.22.4.12409

Downloads

Published

2016-12-01

Issue

Section

METALS, ALLOYS, COATINGS