Decarburisation Effect on Hardened Strip Steel Fastening Components

Authors

  • Karli JAASON Tallin University of Technology
  • Priidu PEETSALU
  • Mart SAARNA
  • Priit KULU
  • Jüri BEILMANN

DOI:

https://doi.org/10.5755/j01.ms.22.1.7467

Keywords:

austempering, endothermic atmosphere, decarburisation, chromium plating, hydrogen embrittlement

Abstract

Heat treatment is widely used for high reliability fastening components such as buckles and brackets. The current study focuses on mass production of safety components which are fineblanked from sheet metal, austempered and chromium electroplated. Electroplating together with stamping defects may lead to unexpected brittle failure of the component. It is widely known that during austenitisation, decarburisation could avoid brittle failure and, therefore, slight decarburisation is recommended. There is little information how much mass production is influenced by decarburisation and where the limits are. The current study has two goals. The first one focuses on the extent of decarburisation effect on the part properties, and the second aims to find the optimum furnace setting for the product type used in the study. Also, it is necessary to choose a reliable decarburisation control method for austempered components. The effect on material grades was analyzed by using three steel alloys with carbon content of 0.37 wt.%, 0.47 wt.% and 0.62 wt.%. The specimens were austempered to hardness 45 51 HRC under endothermic protective atmosphere. To gain different decarburisation levels, two gas set-ups were used. Infrared gas analyzer was used to measure CO and CO2 content in the furnace gas. Three characteristics of the specimens were evaluated: hardness, rupture strength and brittleness. The depth of the decarburisation was determined by three different approaches according to standard EN ISO 3887. Based on the results, the spectrographic method is the most reliable for determining the depth of decarburisation. This study reveals that higher surface decarburisation has a positive effect on the ductility and no effect on the rupture strength of the component. The material with carbon content of 0.62 wt.% is the most sensitive to decarburisation. During mass production, the inaccuracy of hardness measuring raises which results in the inaccuracy of salt bath temperature regulation. For the used thermal cycle, the furnace gas carbon potential 0.30 0.40 has to be used to ensure expected performance of fastening products.

Author Biographies

Karli JAASON, Tallin University of Technology

Department of Materials Engineering

Priidu PEETSALU

Mart SAARNA

Priit KULU

Jüri BEILMANN

Downloads

Published

2016-01-21

Issue

Section

TESTING AND ANALYSIS OF MATERIALS