Modeling of Processes in Co-Based Coatings Exposed to Plasma Jet Irradiation

Authors

  • Tatyana KOLESNIKOVA D.Serikbaev East Kazakhstan State Technical University
  • Darya ALONTSEVA D.Serikbaev East Kazakhstan State Technical University
  • Alexander POGREBNJAK Sumy State University
  • Alyona RUSSAKOVA L.M. Gumilev Eurasian National University

DOI:

https://doi.org/10.5755/j01.ms.19.3.1903

Keywords:

computer simulation, plasma-detonation coatings, structure-phase compositions

Abstract

The model of microstructure of thick (about 300 μm) plasma detonated Co-based coatings on steel substrates is suggested on the basis of experimental research. Computer simulation of temperature distribution in depth from the surface of coatings under plasma jet irradiation was done; and certain parameters for additional treatment by irradiation were proposed. The irradiation was carried out according to the design conditions. It was established that the roughness of the modified coatings decreased by 2 times, microhardness increased on the average by 25 %. There was established the evolution of the structure and phase composition of the coatings after irradiation, which caused the improvement of their strength.

DOI: http://dx.doi.org/10.5755/j01.ms.19.3.1903

Author Biographies

Tatyana KOLESNIKOVA, D.Serikbaev East Kazakhstan State Technical University

Faculty of Information Technologies and Power Engineering, Deputy Dean

Darya ALONTSEVA, D.Serikbaev East Kazakhstan State Technical University

Department of Instrument Engineering and Technology Automation, Associated Professor

Downloads

Published

2013-09-17

Issue

Section

METALS, ALLOYS, COATINGS