Manufacturing Methods of Complex-shaped Powder Components

Authors

  • Victor Alexandrovich MIRONOV∗ Labour of Powder Metallurgy, Riga Technical University

Keywords:

powders, sintering, complex-shaped component infiltration, joining of powder details.

Abstract

Main directions of the manufacture of powder articles of complex configurations are considered. Results of investigations in which complex-shaped articles were prepared by pressing on hydraulic presses, magnetic pulse compaction, joint sintering of several powder components, infiltration, and brazing are presented.
In order to increase the strength and density of joints, the method of infiltration of powder components with copper melt was used. Factors influencing the infiltration process and properties of articles are analyzed. Examples of applications of components consisting of several elements are presented.

Downloads

Published

2006-06-15

Issue

Section

METALS, ALLOYS, COATINGS